Power Supplies - 100-250 kW 1,000 or 3 kHz

• Simplistic Design and Clean Construction for Easy Operation and Low Maintenance
• Cabinet is Rugged 10 Gauge Steel Construction with Welded Seams
• All Components readily Accessible through Front and End Door for Easy Service and Maintenance
• Can be Flush Mounted Against a Wall
• High Electrical Efficiency
• Single Electronic Logic Board in Isolated Enclosure
• Fast Acting Circuit Breaker that Trips In One Cycle or Less in the Event of an Inverted Fault, Prevents Loss of Expensive Fuses
• Diagnostic Circuit Monitor shows where to locate faults and indicates electronic Limits
• Logic Can be Interfaced with PLC's and Temperature Controllers

Options

• Three Phase SCR Controlled Bridge (Electronic Switch) Shuts off Power to Inverter In One Cycle or Less in the event of an Inverter Fault, Prevents Loss of Expensive Fuses and/or Damage to Circuit Breakers
• Cabinet is Setup for the addition of up to three furnace selector switches for alternate operation of Multiple Furnaces
• Internal Closed Water System protects all Power Supply Components from Dirt and Electrolysis - This System, built into the power supply, cools all components with low conductivity distilled water. The external water source cools the internal system plate type heat exchanger and furnace
• Cabinet can be manufactured "Right Hand" as shown or "Left Hand" (mirror image)

Important Note About Cooling Water:

Controlling water quality is the "Secret" to trouble free operation and long life of induction equipment. Severe damage from electrolysis, scaling, blockage and over heating can result from poor water quality. The best way to prevent these problems is with a Closed Loop Cooling and Recirculating Water System where water conductivity and cleanliness can be maintained. ITC can offer a sophisticated closed loop external cooling and circulating system or an internal closed loop recirculating system. Either Closed Loop Water System will extend the warranty on this power supply.

100-300kW BROCHURE: