Power Supplies - Up to 100 kW 3 kHz or 10 kHz

• High electrical efficiency
• Single electronic logic board in isolated enclosure
• Cabinet is rugged 10 gauge steel construction with welded seams
• All components readily available for easy service and maintenance, main access is from rear as shown
• Fast-acting circuit breaker that trips instantaneously in event of an inverted fault, prevents loss of expensive components and fuses
• Simplistic design and clean construction for easy operation and low maintenance
• Logic can be interfaced with PLC's and temperature controllers

Options

• Low Voltage Output Transformer for small heating applications.
• Two Furnace Selector Switches for multiple furnace connection.
• Internal Closed Water System protects all power supply components from dirt and electrolysis. This system is built into the power supply and cools all components with low conductivity distilled water. The external water source cools the internal system's plate type heat exchanger as well as the furnace.

Important Note About Cooling Water:

Controlling water quality is the "Secret" to trouble free operation and long life of induction equipment. Severe damage from electrolysis, scaling, blockage and over heating can result form poor water quality. The best way to prevent these problems is with a Closed Loop Cooling and Recirculating Water System where water conductivity and cleanliness can be maintained. ITC can offer a sophisticated closed loop external cooling and recirculating system or an internal closed loop recirculating system. Either Closed Loop Water System will extend the warranty on this power supply.

MVP BROCHURE: