Power Supplies 15 kW to 35 kW to 9 kHz

• High Electrical Efficiency
• Single Electronic Logic Control Board
• Cabinet is rugged 10 gauge steel construction with welded seams
• All components are readily accessible through a front door for easy service and maintenance.
• Output power connection can exit out of either the lower left or lower right side of the cabinet.
• Fast acting Circuit Breaker, flush mounted on the side of the cabinet, will trip in one cycle or less in the event of an inverter fault. This prevents the loss of expensive components and fuses
• Diagnostic lights on the front panel monitor electronic controls and safety interlocks.
• Simplistic design and clean construction for trouble free operation and low maintenance

Options

• Two Furnace Selector Switches for multiple furnace connection
• Closed Water System for power supply components. This system cools all power supply components with low conductivity distilled water. An external water source cools the plate type heat exchanger and furnace. This option can be attached to either side of the cabinet or supplied on a free standing frame.
• Logic can be interfaced with process controllers for automatic temperature control of the load.

Important Note About Cooling Water:

Controlling water quality is the "Secret" to trouble free operation and long life of induction equipment. Severe damage from electrolysis, scaling, blockage and overheating can result from poor water quality. The best way to prevent these problems is with a Closed Loop Cooling and Recirculating Water System where water conductivity and cleanliness can be maintained. ITC can offer a sophisticated closed loop external cooling and recirculating system or a power supply closed loop recirculating system. Either Closed Loop Water System will extend the life of this power supply and reduce costly maintenance.